ikuo78's latest activity
-
These arrived today from a junkyard on the eBay. Some poor old Nitro doesn’t need them anymore. o_O I have them soaking in Free-All in... -
ikuo78 replied to the thread Project to divert KK coil to KJ.The plastic valve cover arrived. The gasket is soft rubber. The lip of the gasket that touches the head is flat. The bolts reached the...
-
-
ikuo78 reacted to nolakj's post in the thread Smooth start and idle but Rough acceleration with
Like.
Turns out it was bad U joints, which was totally off my radar having had them replaced 3 weeks ago. Shoddy workmanship by my... -
Job done. Couldn’t have been easier. I wish I had bought the torch a long a long time ago! Also a 22 mm closed end wrench was important...
-
Bad news… My 4” lift JBA adjust a strut on the drivers side had a catastrophic failure. The steel shaft of the shock (not sure what it...
-
ikuo78 replied to the thread Very dizzy, increased heartrate while driving. (Mechanical advice only).I recommend using a CO alarm when using a stove in a tent...
-
-
Quick Update (2) Oem Engine Core Plugs “one above the starter, one above the right motor mount New Front right Motor Mount Oem Mopar...
-
ikuo78 reacted to duderz7's post in the thread Rear suspension or axle clunk when getting on or off the gas. with Like.
Jack it up by the axle so it's closer to ride height during inspection. The bushings mentioned would be a good place to start, next the...
-
ikuo78 reacted to u2slow's post in the thread Rear suspension or axle clunk when getting on or off the gas. with Like.
Upper arm bushings. They tear. Best viewed when not jacked up. It is very difficult to remove the OEM bushings without stretching the...
-
ikuo78 replied to the thread What did you do to your jeep today?.But I would be in trouble if this method completely fixed the oil leak. The plastic valve cover, which cost $120 including shipping, has...
-
Sometimes you can't get them to stop leaking without using the u shape with the two wings so it pulls down on more of the cover. Old...
-
I couldn't wait, just went and put one in. It the rh side, drivers side here in the UK. I swapped the nipple's to grub screws, didn't...
-
ikuo78 replied to the thread What did you do to your jeep today?.The valve cover is still dripping oil. I removed the grommet from the mounting bolt and checked the tightening, but it was only...
-
-
ikuo78 reacted to u2slow's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
Bilsteins aren't worth paying extra for IMHO. Ours had them on the rear and I went to Monroe's after lifting. On my Dodge, Bilsteins...
-
ikuo78 reacted to KJowner's post in the thread Looking the upgrade my suspension on 2005 jeep liberty with Like.
H&R springs and some new shocks will freshen it up nicely.
