Recent content by Gyro
-
What did you do to your jeep today?
They are a bit heavier,wider to better fit a wider tire and more offset which puts the tire about even with the outer edge of the flare without using spacers. Oh and they look cool!:D Gyro- Gyro
- Post #28,016
- Forum: KJ General Discussion
-
What did you do to your jeep today?
Had my transmission pan and filter changed yesterday. Pan had developed a small weep hole on the leading edge. And it just recently rolled over 120,000kms. It had 59,000kms when I traded my 07 Dakota for it in 2012. Gyro- Gyro
- Post #28,013
- Forum: KJ General Discussion
-
Rear door window
I'm pretty sure you have to get the whole regulator assembly. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Best repair manual?
Service manual and parts fiche downloads for years 02-06 can be found here, https://www.colorado4wheel.com/manuals/Jeep/KJ/ Gyro -
Pulley & Harmonic balancer would this tool work on Liberty 3.7
A three jaw puller is recommended. like this https://partsavatar.ca/wilmar-unspecified-tool-w136p?l=C_No_Revenue&campaignid=555288329&adgroupid=1137996311680161&creative=&matchtype=e&network=s&device=c&keyword=&msclkid=3bb6a0f842af1a649bf4c96e1b20734e Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Suggestions for a '05 Limited KJ Modest Lift
I got my new set last year at Tdotperformance.ca in Toronto,they shipped from Lethbridge, to Nova Scotia. Check them out.- Gyro
- Post #30
- Forum: Lift Kit Discussion
-
What's acceptable for spring sag on a KJ?
Yes it works for all years. Gyro- Gyro
- Post #4
- Forum: KK General Discussion
-
Ok, I guess I was asking for it, 4x4 question
It's the transfer case binding and popping. The solution is to pop it out of part time 4x4 once in awhile and if feels tight to shift out you can reverse a little to relieve tension on the shift lever. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Water Pump questions
That is normal for the HD cooling package. I assume you also have a factory tow hitch and 7 wire trailer electrics. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
02-05 front end on an 05
You could Yes, but why?:) If you do,you will need the 02-04 front fender flairs as well. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
2005 Back Glass seal/weather strip with strut mount on it.
There are 2 soft rubber seals,one circles the opening(55176958AG),the other is on the door itself(55260065AB). The hard plastic piece that is on the back of the glass,comes as part of the glass. Check with a local glass installer for the right adhesive. Gyro- Gyro
- Post #3
- Forum: KJ General Discussion
-
Jeep slams influencers who pull apart new Recon at LA Auto Show
It looks like they just ballooned a Renegade. And for just $91,000 CDN pre tax,of 14%. 2 thumbs down and a couple of fingers up. Gyro -
Winch ideas KJ
"Detours Backbone" for KJ might interest you.They are discontinued,but a used one may be out there. One for sale here https://www.jeepkj.com/threads/feeler-detours-usa-backbone-winch-mount.75728/ but it is an older post but they my still have it. There should be images of it on google. Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
Harmonic balancer bolt size?
M14X1.50X112.00 is the correct size Gyro- Gyro
- Post #2
- Forum: KJ General Discussion
-
What did you do to your jeep today?
All kinds of nice goodies here:https://www.ironrockoffroad.com/category/kj-2002-2007-liberty-9191.html- Gyro
- Post #27,470
- Forum: KJ General Discussion
