Recent content by DesmondG

It’s great to see everyone chipping in. I will make sure to get pics and update here as much as I can. Thanks again everyone.

Will do Dave! I will be digging right in to mine. Outer and inner will be replaced. I also have to address rust around my middle brake light at the back. Right now I have it at the mechanics to get a pre safety to see what else is wrong and need of repair before I dig too far. It hasn’t been...

Thanks @daves06lrenegade I will check them out. I have a sheet metal company near by. Might see if they can bend some up for me as well. The inners that is.

I think the best thing to do is start by taking the putter skins off and start tapping around with a hammer and see how bad it is on both sides before I decide what I need.

So is the part that I am looking for called the sill?

Do you know where I can find inner panels? Or will I need to find some metal and try to make my own? Thanks, I don't mind welding in new pieces, just need to find panels.

Ya it’s about the same on the passenger side as well. I like be in Ontario so I do have to have a safety inspection done which this will not pass so I do have to weld in new inner and outer rockers. I don’t mind doing that as I have done work like this in the past. I cannot seem to find the...

Hey everyone. I found myself a 2005 Liberty 4x4. After driving it home, I climbed underneath and noticed that the putter part of the frame is rotting? I though of this area to be inner rocker panel but I’m new with these Liberty‘s so I hope I could get some feedback from you experts on here. I...