Search results

I have retrained the sensors again...same thing. I have the 4 sensor system. This problem just started last week. There is a mode that you can go in that counts the sensor output signals to the evic. Seems fine all sensors are sending signals at about the same rate. Any ideas?

03 liberty. I am getting a bad/missing sensor error. Evic shows all 4 sensors. Went into diagnostics mode. All 4 sensors are counting at about the same speed, yet I keep getting the message. Need a Guru please. Thanks

I had the blue wire coming off the EVIC going to F20. I switched it to F6 and all my problems are solved. Let me know if this helps anyone else out. Everything has been working properly for 1 week now. Mark

It gets its constand power from the fused B+ pink wire. I am having the same issue. The Blue/While wire should only get power with the ignition on. Otherwise the evic would always be lit up, I think. I may try it just for S**** and grins. This is a very annoying problem! I just like things...

Yes...Same thing happens to me with rear doors if I have one open, start the jeep and then close the door. I have not tried the lift gate yet. There has to be a EVIC or BCM software upgrade to fix this. I have a 2003 vehicle and a 2003 EVIC. Does anyone know how to "Flash" either of...

No...It's not saving settings because the setting that you put in will stop functioning.

I have recently installed an evic in my 03 and it will not save settings correctly either. Sometimes it will last a day at most. I checked all the wiring and all is good. I have constant 12vdc to pink and blue is correct also. Grounds are good. Has anyone found a solution to this...