Search results

I could really use the 2004 service manual, I bought the Chilton book and doesn't have what I need. Thank you in advance.

I'm certain than none where bent! It happened after assembly but I don't know how. Thoughts?

Im fairly confident I have a bent valve stem. For it won't spin and the others will. I'm holding off removing the head until I do a leakdown test.this way I can hopefully discover other possible issues that need attention. Does that sound about right?

Thanks alot I'll find a leak down kit tomorrow, I have a compressor. So I'll give it a shot and see what happens. Cross your fingers for. Lol

I turned it over with a gauge in the spark plug hole. In the interim I have again taken it apart, valve cover and intake. The same rocker was off, and I know it's not the rocker due to I had swapped it with another and installed the new lifter before reassembly last time. It's not real easy...

Awesome, it looks like I'm going to hunt down a lash adjuster. Thanks alot for your input, and have a great day!!!!

Not sure what "cel" is? What I found is one of the rocker came off. The lifter looked good, It was stuck in the collapse position. So what I did was to put it back in position thinking that I must have made a mistake when installing, got it all put back together for it to run fir approx 10 sec...

Thats true I hope that is what it is.

Thank you for you input, i replaced all three timing chains, water pump all associated gaskets, head bolts, fuel injectors, coils, and spark plugs, no extra bolts or lost bolts, but i do recall thinking one of the rocker didnt look right. and I do have an endoscope to look into the cylinders...

That's good information, thank you for you input. Im hopeing that is my problem!

Do you know what kind of damage it could have caused?

Thats what I was thinking also thanks

My 04 jeep liberty with 100k miles had a blown head gasket, caused by a radiator blowing, and overheating causing a slight warp of the heads I replaced both head gaskets and had them machined before installing, I started it up and it ran good for 10 seconds, then I heard a metallic sound and it...

My 04 jeep liberty had a blown head gasket, replaced both head gaskets and had them machined before installing them, started it up and it ran good for 10 seconds, then I heard a metallic sound and it instantly shuddered, I turned it off at the same time. not sure what I should do, I'm thinking I...