Recent content by Omargz
-
O
Grease fittings for lower ball joint
The problem was that NAPA gave two different lower ball joints, and I didn’t realize that until installed with 90 degree zerk fitting. It was making contact with the CVC hub. When I started the driver side is when I noticed that it had the zerk fitting on the side.. I should have looked all the...- Omargz
- Post #20
- Forum: KJ General Discussion
-
O
Grease fittings for lower ball joint
I tried the 90 degree zerk fitting. It hits the cvc hub also. The rotor would not turn, had to pull everything apart. Then added some grease and found a ceil fan screw for the fan blades fit. The one for the left side was I needed picture is without the zerk fitting installed. NAPA ordered two...- Omargz
- Post #17
- Forum: KJ General Discussion
-
O
What did you do to your jeep today?
Replacing upper and lower ball joints, right side done. Hopefully finish the left today.- Omargz
- Post #25,828
- Forum: KJ General Discussion
