Go Back   Jeep Liberty Forum - JeepKJ Country > Members List

KJmurf KJmurf is offline


Visitor Messages

Showing Visitor Messages 1 to 7 of 7
  1. KJmurf
    09-30-2015 10:36 AM - permalink
    The pics are in my Fabrication album. Also, I used the "indentation" on the fender well as my bending template. That indentation can be seen in some of the pics when the fender is off. Tip: When using the pipe bender on steel tube, you use the bender die that is 1/2 " smaller than the tube you are using, ex., I used the 1/2" die for 1" steel tube. When I made my rock sliders, I used the 1 1/2' die for 2" steel tube.
  2. KJmurf
    09-30-2015 10:29 AM - permalink
    Sorry for the delay, I have not been on the site for a long while. I did make them. I used a harbor freight pipe bender, 1" tube steel, some plate steel, and harbor freight bedliner. I think there are some pics on one of my albums. After taking the fenders off, I used the existing hole locations for my 1/4" bolt locations. Let me know if you need anymore info. I will tell you that it was a pretty fast project, just a lot of "bend pipe" then "eyeball", repeat process.
  3. MacAndrew93
    09-06-2015 11:58 PM - permalink
    Hello, I noticed those awesome fender flares on your Liberty. I like that style and have been wanting one's like those on my liberty but I can't find any. Did you make those yourself? Did you buy them? Any help you could offer would be greatly appreciated.

    Thanks, Awesome Jeep man
  4. KJmurf
    02-25-2015 10:47 AM - permalink
    Sorry...for some silly reason I thought you were sending them to me, but I see the benefit of posting for everyone...guess I'm just a selfish SOB. Looks awesome and a great fit.
  5. profdlp
  6. KJmurf
    04-24-2014 09:43 PM - permalink
    I have no doubt...
  7. profdlp
    04-24-2014 05:19 PM - permalink
    I will soon. The front seats looked so good I am planning to take out the back seat and make sure it looks equally good. Been on the phone all afternoon doing job interviews. (I think if those folks could see my smiling face in person I'd have a better shot at getting hired.)


Total Posts
Visitor Messages
General Information
  • Last Activity: 11-18-2017 01:27 AM
  • Join Date: 03-20-2013
  • Referrals: 0

GM Truck Forum
Ford Raptor Forum
Chevy Tahoe Forum
Chevy Cobalt Forum
Chevy Camaro Forum
Toyota FJ Cruiser Forum
Ford Truck Forum
88-98 GM Truck Forum
73-87 Gm Truck Forum
Ford Expedition Forum
Chevy Equinox Forum
Chevy Cruze Forum
Dodge Ram Forum
Jeep Forum
Dodge Ram SRT10 Forum
Chrysler 200 Forum
Scion xD Forum
Scion xB Forum
Dodge Challenger Forum
SRT Forum
Nissan Titan Forum
Buick Enclave Forum
Cadillac Forum
Cadillac XTS Forum